Author Archives: Rondex
Posted on March 27, 2012 by Rondex
In need of quality autobody supply and equipment?
Posted on March 27, 2012 by Rondex
Here at Rondex we know the value of that perfect blend. You spend hours, days, weeks or even months looking for the perfect color. So, when it comes the time to touch up the paint work, we know how important … Continue reading →
Posted on March 20, 2012 by Rondex
Using aerosols can produce great results, and it doesn’t have to cost you a fortune. There are a couple of ways to make spray bombs work for your needs. The key to getting the most use out of your spray … Continue reading →
Posted on March 13, 2012 by Rondex
An aerosol or spray bomb, basically works using compressed air as a propellant for the product in the can. One of the most common faults reported with this type of product is a clogged nozzle, which prevents the spray from … Continue reading →
Posted on March 6, 2012 by Rondex
Cleaning your spray gun is a relatively easy process. When done correctly, you can be sure that your spray gun will continue to perform for you well beyond your expectations. As always, observe health and safety when dealing with tools … Continue reading →
Posted on February 28, 2012 by Rondex
Clean the Repair Area It is important to make sure your repair area is clean, when blend panel sanding. This is a two-step process. First of all use soap and water to clean surface dust and dirt away. Follow up … Continue reading →
Posted on February 24, 2012 by Rondex
Prepare the Surface Before you begin any masking job it is important to prepare the surface. The first step is to use a water-based cleaner on the repair area. Next you will need to clean the area again using a … Continue reading →
Posted on December 23, 2011 by Rondex
All of us at Rondex, join in saying “Thank You” and Wish you all the best this Holiday Season.
Posted on December 14, 2011 by Rondex
A plastic welder is used to join or repair thermoplastic materials. This tool works by creating temperature high enough to make plastic melt and get molded by the welding bar. There are different types of plastic welders. Some are portable … Continue reading →
Posted on December 13, 2011 by Rondex
Clearcoats and hardeners tend to become more viscous during the cold season if not stored properly. Paint material should have a temperature of 20 to 25 degrees C for spraying to ensure the best reaction between the clearcoat and the … Continue reading →
